welding, Mechanical Engineering

Why is the quality of welds produced by submerged arc welding very good#Minimum 100 words accepted#
Posted Date: 8/9/2018 1:24:42 PM | Location :







Related Discussions:- welding, Assignment Help, Ask Question on welding, Get Answer, Expert's Help, welding Discussions

Write discussion on welding
Your posts are moderated
Related Questions
Reversible and irreversible processes: Thermodynamic system which is capable of restoring the original state of it by reversing the factors responsible for occurrence of proc

Q. General Design Requirements for Steam Generators? The Steam Generators shall be once-through type; with a parallel-pass arrangement, direct fired, and consist of a combustio

Objectives After studying this section, you should be capable to understand: Cell control and modeling, Context level data flow diagram, A common cell control sy

(a) What is the use of ball race drive? (b) How should one install the bottom cone race? (c) What is the use of front fork oil seal driver body and its attachment? (d) Wha

Please help me solve the following problem. Steam is throttled from a pressure of 700kPa to 100kPa and a temp. of 100 degrees Celsius. Determine the dryness factor of the steam

Alignment of a Railway Line: Selection of Alignment The following points must be considered in selecting the alignment of a railway line : (a) It should be as direct

Compare otto cycle with Diesel cycle: Sol.: These two cycles can be compared on the basis of either the same compression ratio or the same maximum pressure and temperature.

This formative assignment seeks to develop and assess skills associated with basic modern ICT tools and competence in the techniques of Rough-Cut Capacity Planning and F inan

Heat Treatment of Tool Steels This treatment in case of tool steels in a significant step before actually employing the tool. Most properties are attained after heat treatment

Problem - Newton's Second Law in 2D A tow truck tows a 1000-kg car by applying a force of 1000 N north-northeast (67.5° above the x-axis).  a)  What are the components of th