Vitrification-manufacturing methods of ceramics, Mechanical Engineering

Vitrification

This is liquid phase sintering. It is achieved via incorporating a component that melts to viscous liquid during sintering. Such viscous liquid solidifies in glassy phase. In a well vitrified ceramic inflexible structure is acquired.

 

Posted Date: 2/27/2013 1:54:23 AM | Location : United States







Related Discussions:- Vitrification-manufacturing methods of ceramics, Assignment Help, Ask Question on Vitrification-manufacturing methods of ceramics, Get Answer, Expert's Help, Vitrification-manufacturing methods of ceramics Discussions

Write discussion on Vitrification-manufacturing methods of ceramics
Your posts are moderated
Related Questions
Quasi static process - thermodynamics: Thermodynamic equilibrium of a system is very difficult to be realized during the occurrence of a thermodynamic process. 'Quasi-static'

Q. 11: What is relation between the maximum tensile stress and the maximum compressive stress in any section of beam? Sol.: L et us assume inverted angle section of the beam a

The press tressed bridge structure would look like as shown below,   The following factors influences the decision to select the particular prestressing, 1/Span of br

Follow board pattern This type of pattern is adopted for those castings where there are some portions which are structurally weak and if not supported properly are likely to br

Disc clutch friction thickness: Check disc clutch friction thickness which should be minimum of 2.6 mm.

Question. Consider the triangular laminar D for given b and h shown below. (a) Find x L (s) and x R (s), the left and right ends of the elementary strip, of thickness ds, a

Remove clutch cover and check clutch operating arm, spring and clutch lifter rod :Check for free movement of rod clutch lifter in the cover right crankcase. Check for lever comple

Draw and Illustrate all the inversions of a double slider crank chain. Get an expression for the length of a belt in 1. an Open belt drive ;  And 2. a Cross belt drive.

send me pipe designing material

The basic aim of synthesis in design process is to provide information which can tell you how to improve the design. In general the synthesis process gives many alternatives of