Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Question
In designig of watermains, how to decide usage of double air valves and single air valves?
Answer Single air control device let squeezing air out of pipeline in automatic mode in high-pressure condition and are usually designed in high direct of watermain in that air voids are present. Double air valves essentially serve same purpose except that it has another important function-it can get air into or out of the pipeline during low-pressure condition. In WSD practice, watermain are in general divided into sections by installation of sectional valves to ease maintenance. In a single isolated pipeline section bounded by two sectional valves, at smallest amount a double air valve should be installed. Throughout normal maintenance operation like cleansing of watermain, water inside pipelines is tired from washout valves. Though, as regular watermain is subject to very high force like 1.5MPa and sudden withdrawn of water will reason a transient vacuum condition and will damage watermain. So at least one twice air valve should be present to let air to squeeze in to equilibrium pressure and this defend pipeline from damaging.
what are the defects in timber
what is the design of syphon
Assignment for marketing mix
What is the external load acting on a pre-stressed beam In the elastic range, a variation in the external load acting on a pre-stressed beam results in a change in the location
What is Thermo-electric prestressing We know that, stretched tendons are used in prestressed concrete. Stretching of tendons may be accomplished by using jacks or by other mea
Define Design Aspects of Pot Bearing? Basic elements of a POT bearing are: - POT or a shallow cylinder - An elastomeric pad - A set of sealing rings - A piston P
Q. What is Multiple-cell box girder? Multiple-cell box girder: cells connected by top flanges vs. cells connected both by top and bottom flanges When the depth of a box gi
• A potential source of harm - Mechanical hazard - Electrical hazard - Cutting hazard - Toxic hazard - Fire hazard - Explosion hazard
A flow rate of 200 gpm of oil with u=1.5 x 10-3 lb-sec/ft2 and p=1.7 slug/ft3 occurs in a 4-in pipe. Determine the Reynolds number. Classify the flow as laminar or turbulent. What
What is Bore Hole In exploration of area of limited extent the borings should preferably be located near the comers of the area. A minimum of three holes should be made un
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd