Types of patterns in manufacturing, Other Engineering

Types of patterns : These  depends upon many factors like the bulk of casting, type of moulding processes, number of castings required and the anticipated difficulty of moulding, on account of the typical shape or design of casting.

            The following kinds of patterns are generally used :

            1.   Solid or single piece pattern               

    2.   Two-piece or split pattern

            3.   Multi-piece pattern                                

    4.   Match plate pattern

            5.   Gated pattern                                         

    6.   Skeleton pattern

            7.   Sweep pattern                                       

            8.   Pattern with loose piece

            9.   Cope and drag pattern                         

            10. Follow board pattern

            11. Segmental pattern

Posted Date: 8/3/2012 1:16:59 AM | Location : United States







Related Discussions:- Types of patterns in manufacturing, Assignment Help, Ask Question on Types of patterns in manufacturing, Get Answer, Expert's Help, Types of patterns in manufacturing Discussions

Write discussion on Types of patterns in manufacturing
Your posts are moderated
Related Questions
Non-discounted cash flow method, Payback period method In this method, time value of money is not considered. It takes into account the number of years required to recover the in

explain coil ?

Riveting  is a fixed fastening procedure in which the end of the metal pin is pressed over or spread out by hammering operation. Wrought iron and steel are used for the riveting an

Oil pressure warning light: Oil pressure is also monitored by an oil pressure switch that puts a light on when the oil pressure reaches a low level. The light is usually red an

Is there anyone on your staff good with HEC-HMS software for modeling rain events?

"Whether you are writing, listening, speaking, or attending meetings, communication skills are critical to your success in University and the workplace". Discuss. Since entering

I need help summarizing a technical paper.

Investment allowance Until a few years ago, a company could charge an amount equal to 25 per cent of the original value of an asset as investment allowance in the period in which

APU Engine APU engines usually consist of a centrifugal compressor and a radial turbine however, axial compressors and turbines may be added or used in their own right. Centrif

Analysis of truste,2D truss analysis using method of joint(cantilever & simply support)?