process planning, Mechanical Engineering

we have to design crane we did already with calculation remaining is process planning
Posted Date: 1/16/2013 3:30:20 PM | Location : Saudi Arabia







Related Discussions:- process planning, Assignment Help, Ask Question on process planning, Get Answer, Expert's Help, process planning Discussions

Write discussion on process planning
Your posts are moderated
Related Questions
Q. Explain Moulding Sand for Non-ferrous Casting? The melting point of non- ferrous metal is much lower than that of ferrous metals. Therefore, the moulding sands for non-ferr

Universal Support of Data Types To address inherent functional incompatibilities, we take the exact opposite route to the 'least common denominator' approach of previous soluti

a circle of 40mm roll on horizontal line.draw the curve traced out by the point for 1 complete revolution.the point is vertically above centre of circle

Find the maximum torque - I-section: An I-section 150 × 80 mm has flanges 6 mm thick and web 4 mm thick. Discover the maximum torque that may be safely applied if the shear st


Custom-Designed Lap Joint Flanges Practices relative to lap-joint flanges, that experience has shown will result in a level of damage tolerance, leak-tightness integrity, and g


Q. Show Mass energy Relation? Until the time of Einstein, mass and energy were considered as two different physical quantities. But in 1905, with the help of postulates of the

Explain Young's Modulus or Modulus of elasticity? Sol. : It is ratio between tensile stress and tensile strain or compressive stress and compressive strain. It can be denote

Clutch free play : Check for free play of the clutch lever. It should be within 10-20 mm.