powder metallurgy, Mechanical Engineering

why pre sintering needed in powder metallurgy
Posted Date: 4/2/2013 9:48:53 PM | Location : USA







Related Discussions:- powder metallurgy, Assignment Help, Ask Question on powder metallurgy, Get Answer, Expert's Help, powder metallurgy Discussions

Write discussion on powder metallurgy
Your posts are moderated
Related Questions
Determine the reaction: The cantilever is shown in the figure given below; determine the reaction when it is loaded.   In cantilever at fixed end ( A ) there is three reac

A copper tube 1.2 m long, has 80mm internal diameter and 2 mm wall thickness. It has closed ends, and is filled with water under pressure. What will be the alteration of pressure i

Intermittent motion Most seam welding machine requirements are met by the use of continuous drive. However, in cases where heavy work parts are to be welded or more than a sing

Q. Corrosion Control in Oil-Treating Equipment? Bitumen provides adequate internal protection for Inlet Slug Catcher, FWKO and Treater. Due to high operating temperature, inter

Classificatio n of I.C. Engines: IC engines are classified as follows: 1 . Nature of thermodynamic cycles as:  Otto cycle engine, Diesel cycle engine and Dual combus

Basic Concept: Like any fine machine a motorcycle can be split into various systems like lubrication system, transmission system, electrical system, etc. It is important that a

Working of stream engine: The high pressure steam from boiler is supplied to the steam chest. The high pressure steam enters cylinder through inlet port and exerts pressure on

CAD-CAM Data Exchange: The interface SET transferred information on wire-frames, surfaces, B-representation and FEM models as well as technical drawings and scientific data. I

boiler performance.

Resultant of Concurrent Force System: The resolution of forces helps in finding out the resultant of a number of forces working on a body as it decrease vectorial addition to