balancing, Mechanical Engineering

A shaft carries three pulleys A,B and C. the pulleys B and C being 1.2m and 2.1m from A. the pulleys are out of balance to the extent of 0.03, 0.05 and 0.04kg.m respectively and are keyed to the shaft sa as to give static balance. find the relative angular positions of the radii which define unbalance. if the shaft is supported in bearings 1.8m apart, find the dynamic loading on each bearing when the shaft rotate at 300rpm.
Posted Date: 12/27/2012 6:34:51 AM | Location : Malaysia







Related Discussions:- balancing, Assignment Help, Ask Question on balancing, Get Answer, Expert's Help, balancing Discussions

Write discussion on balancing
Your posts are moderated
Related Questions
CONSTRUCTIO N and WORKING: The boiler barrel is cylindrical shell and consists of large number of flue tubes. The barrel comprise of a rectangular fire box at one end and a

(a) Oil, with density ρ= 900 kg/m 3 , and kinematic viscosity υ=0.00001m 2 /s, flows at the rate of 0.2m 3 /s through 500m of a cast iron pipe of diameter d=200mm. Using this infor

What is the difference between counter flow and parallel flow Heat exchange. Classify Heat exchange on the basis of constructional features and design.

Determine- cutting speed, Material removal rate and Machining time. A 150 mm long 12.7 mm diameter stainless steel rod is being turned to 12.19 mm diameter on a centre lathe.

Rockwel l Hardness Test: The specimen is subjected to a major load for about 15 seconds after the initial load. ASTM says 13 scales for testing of wide range of materials. Th

Define Disadvantages of electro discharge machining? a) The wear rate on the electrode is significantly higher. b) The work piece must be electrically conductive to be machi

Is there a metal that does not contain iron? Ans) Most commercially available aluminum having some other materials, but only accidental traces of iron, if any. For example, Copp

(a) What are the disadvantages of not washing a motorcycle before servicing it? (b) List the parts on which water should not fall directly. (c) Write down the steps for washing and

Q. Can you implement Compatibility test ? This test indicates the decrease in height of a mass of sand in a specimen tube with respect to its original height, under the actio

This components extensively used teh specialized and / or general purpose software. Often it may development for typical application and to perform calculations in the design