thermocouple, Mechanical Engineering

calibration curve standard temparature vs indicator temprature.
Posted Date: 3/2/2013 12:45:37 PM | Location :







Related Discussions:- thermocouple, Assignment Help, Ask Question on thermocouple, Get Answer, Expert's Help, thermocouple Discussions

Write discussion on thermocouple
Your posts are moderated
Related Questions
simply supported beam subjected to point loads results

ELECTRODE WIRE FOR CO2 WELDING CO 2 welding wire must have a special composition to withstand the oxidising nature of the CO 2 arc atmosphere. Though, CO 2 is not reactive a

Q. Effect on the corrosion rate of carbon steel? The velocity of the acid has a significant effect on the corrosion rate of carbon steel. The recommended velocity range for pi

Kennedy theorem

WHAT IS SPECIFIC HEAT

Drive an mathmatical expression for condition of maximum discharge through the chimney. Dry saturated steam is supplied from a boiler to a steam engine at a pressure of 15 bar.

Two concentric perforared plates are seperated by a 200mm launder and form the flow exit for a clarifier (figure 1). The inlet water flow of 1200 mcubed/hour into the clarifier is

Q. Explain basic types of Sand testing? Moulding sands should be of proper quality to meet the required level of accuracy and surface finish of castings. Proper quality of the

Determine the maximum torque - shaft: Determine the maximum torque that can be safely transmitted by a shaft of 400 mm diameter, if (a) the maximum allowable shear stress i

Q. Ultrasonic Examination? Ultrasonic examination, UT and the acceptance criteria shall be in accordance with the Code and performed in accordance with written procedures. W