Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Test Analysis:
First new sand blasting machine prototype had arrived Asia. Installation of the machine had been carry out by external vendor. We test run the machine and the result was not meeting the level of expectation.
The test was carried out, whereby the sand blast nozzle shown smooth vertical movement and the speed of blast is capture by pressure gauge 3.0 bars. We can see minor vibration from machine and low noise produce from sand blast process. In sand blasting process is very stress on stabilizing condition and smoothen of the nozzle movement.
We also need to consider the blasting room design. If the design did not build out aerodynamically it will cause whatever blast will be bounce back and worst case it would damage our product. There is also a need on the distance between blasting nozzle and work piece varies according to the desired blasting intensity.
In selection of material handling equipment itself Hageman indicates that the final consideration are: 1. Methods of Installation: Operating controls should be accessibl
Q. Safety and Loss Prevention? Are there special venting requirements for flammables and toxic materials? Air conditioning, heating and ventilation: • are non-sparking fa
Q. Illustrate types of pipe racks? The following types of pipe racks may be required: • Interconnecting pipe rack (elevated). • Unit pipe rack (elevated). • Pipe ra
Constructive Solid-Geometry Methods (CSG) Constructive models represent a solid as a combination of primitive solids. This modeling technique combine the volumes occupied by ov
Polyhedra and Euler's Formula The b-rep of a polyhedra that are holomorphic to a sphere are topologically valid if they satisfy the following equations : F - E + V - L = 2 (
(a) Draw P-H and T-S diagrams for following cases : (3) (i) Cycle with superheated vapour before compression. (ii) Cycle with sub-cooling or under-cooling of refrigerant.
Standard for the specific standard technical areas These norms are based on previously described models. Typical categories of these norms are: (a) drafting, which describe
applications of dynamically induced emf
Give a generalized definition of factor of safety. Illustrate the factors responsible for Un-certainities in design necessitating a suitable factor of safety. How is ‘factor of saf
Gradual Engagement : The clutch should positively take the drive gradually without the occurrence of sudden jerks.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd