Tap switches, Mechanical Engineering

Tap switches

There are elements for connecting the various taps on the primary winding of the transformer to the power supply line. The switches are usually of the rotary dead front type and are arranged for flash mounting in opening in the machine frame or directly on the transformer. On very large transformers, spring contact switches are inadequate and bolted bar jumpers, are used. All the resistance welding transformers are of load tap changing type only.

Posted Date: 9/17/2012 5:22:57 AM | Location : United States







Related Discussions:- Tap switches, Assignment Help, Ask Question on Tap switches, Get Answer, Expert's Help, Tap switches Discussions

Write discussion on Tap switches
Your posts are moderated
Related Questions
SAFETY IN TIG WELDING-Radiation Energy Hazard Radiant energy may cause injury to the welder in two areas, eye and the skin. Any personnel, whether the welder, inspection person

Ratio of belt tension: For Open belt drive:   Angle of contact (θ) for larger pulley = ∏ + 2α Angle of contact (θ) for smaller pulley = ∏ - 2α For cross belt drive:

Titanium Alloys Pure titanium is a light weight and strong ductile metal. This is very strong and as well as highly resistant to corrosion of all kinds but has the drawback su

(a) Why do we change the engine oil at periodic intervals? (b) What are the recommended instructions to change engine oil? (c) How will you measure the engine oil level?

Advantages of Pinion Cutter Generating Process 1. A single cutter can be used for cutting all spur gears of identical pitch as that of the cutter. 2. Internal gears can be g

Compute the velocity of a bar: A bar AB as shown in Figure slides so that its bottom point A has a velocity of 4 m/sec to the left along the horizontal plane. compute the velo

Q. Explain the procedure of Rockwell hardness tests? Rockwell hardness tests per ASTM of the deposited weld, and heat affected zone shall be required for procedure qualificatio

Test Analysis:             First new sand blasting machine prototype had arrived Asia. Installation of the machine had been carry out by external vendor. We test run the machi

What are the Types of interface An interface can be regarded as an aggregate of conditions, rules and conventions which describes the information exchange, between two communic

A bump/impact test is a simple technique used to determine a structure’s natural frequency. Sketch a typical time wave response curve of such a test, then label the impact point an