Submerged arc welding, Mechanical Engineering

Submerged Arc Welding

 

Single pass filler welds upto (8.0 mm) maximum and groove welds made with a single pass or a single pass each side, may be made using an E7os-x electrode flux combination.

Posted Date: 9/18/2012 1:50:49 AM | Location : United States







Related Discussions:- Submerged arc welding, Assignment Help, Ask Question on Submerged arc welding, Get Answer, Expert's Help, Submerged arc welding Discussions

Write discussion on Submerged arc welding
Your posts are moderated
Related Questions
Q. Shipping of steel pipes? Pipe will be transported from the coating yard to the job site as specified in the Purchaser Order. The Applicator will ensure that the pipe has suf

Q. Carbon and Low Alloy Steels for Welding? All welding of pressure retaining equipment must be completed as per the respective code, typically ANSI/ASME B31.1 or Section VIII

Applicability of value engineering: Usually, all of the initial costs of a project add up to less than 50% of the total life cycle cost

Expression for the normal and tangential stresses: By sing Mohr's circle, derive expression for the normal and tangential stresses on a diagonal plane of material subjected t

sensitivity of governors

Over-Hanging and Cantilever Beam: Over-Hanging Beam: The beams on which one end or both ends are overhang are called as overhanging beam. 3. Cantilever Beam:

Closed, open and isolated system-Thermodynamics system: Sol: In thermodynamics the system can be defined as the quantity of matter or region in space upon which attention is

The greasted and least resultant of forces performing on a body are 35 KN and 5 KN respectively. Calculate the magnitude of forces. What could be the angle between these forces if

Maximum Extraordinary Effect Determine the direction of propagation in quartz (ne = 1.553 and no = 1.544) at which the angle between the wave vector k and the Poynting vector S

The following data were obtained from a test on a single cylinder, double acting steam engine fitted with a rope brake. Cylinder diameter 200mm Stroke 250mm Speed 5rev/min Effec