Steps to develop microprocessor based computer system, Electrical Engineering

Assignment Help:

Explain in brief steps to develop a Microprocessor based computer system.

The design of a microcomputer system should begin with the CPU module. It modules establishes the fundamental system timing, give an orderly means of starting up the processor, and give access to the system buses.

The second step is adding Memory, this is necessary to the stored program computer. By this unit CPU fetches instructions directing this in some task. But in a particular computer system there may be some types of memories all with its own hierarchy.

The third step is adding input/output: It is also termed as has user interface. Here basically two hardware methods for getting data in and out of a computer. First one is the parallel interface and for microprocessor it is the most natural. The second technique is the serial interface.


Related Discussions:- Steps to develop microprocessor based computer system

Major advantages of fet transistors over bjt transistors, Q. What the major...

Q. What the major advantages FET transistors over BJT transistors? a. BJT transistor (bipolar junction transistor) is a bipolar device - the prefix bi-revealing that the conduc

Draw the power triangle for each load, Q. Two balanced, wye-connected, thre...

Q. Two balanced, wye-connected, three-phase loads are in parallel across a balanced, three - phase 60- Hz, 208-Vsupply. The first load takes 12 kWat 0.6 power factor lagging, and t

Cpi compare immediate instruction , CPI Compare Immediate Instruction ...

CPI Compare Immediate Instruction The 8 bit  data  specified  in the  instruction is  compared with the  contents of the accumulator. The comparison  is done by  subtracting

How 8255 programmable peripheral interface can operate, What are the differ...

What are the different modes in which 8255 Programmable Peripheral Interface (PPI) can operate? Twenty Four I/O lines in 38-bit port groups - A, B and C A and B can be

Find the corresponding change ib in the base current, Q. Using the small-s...

Q. Using the small-signal equivalent circuit of a BJT with gm = 0.03 S, β = 75, and VA = 65 V, a load resistor RL is connected from the collector to the emitter, as shown in Figure

Calculate the power required from power plant, You will develop a simulatio...

You will develop a simulation that will consist of the following five components: Controller: This script component controls the simulation. It shall permit the user to: 1. C

Dc machines, commutator in d.c machine acts as... what????

commutator in d.c machine acts as... what????

Explain series capacitors, Explain Series capacitors These are connecte...

Explain Series capacitors These are connected in series with the line conductors and are used to reduce the inductive reactance of long transmission lines and hence the voltage

Derive the expression for steady state error, Derive the mathematical expre...

Derive the mathematical expression for steady state error of first order system with unit ramp signal. Discuss the following - proportional cum integral control - proporti

Obtain an expression for the closed-loop transfer function, Q. A noninverti...

Q. A noninverting op-amp circuit and its closed-loop representation are given in Figure. Obtain an expression for the closed-loop transfer function H(ω) = Y (ω)/X(ω) and comment on

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd