Simple rules-priority rules-conventional priority rules, Mechanical Engineering

Assignment Help:

Simple Rules

FIFO (first in first out) PNj = taj

SPT (shortest processing time) PNj = oj

ODD (earliest operation due dates) PNj = tdj

EDD (earliest job due date) PNj = tdj *

SL (slack) PNj = tdj* - t - wj* * = tsj *

CR (critical ratio) PNj = (tdj - t) / (tdj - tdj - oj)

SL/OPN (slack per remaining operation) PNj = tsj / nj*

SL/RPT (slack/remaining processing time) PNj = tsj / wj*


Related Discussions:- Simple rules-priority rules-conventional priority rules

Chemistry, Note on scale and sludge?

Note on scale and sludge?

Design ia-32 instructions, 1.  Given the data below, design IA-32 instructi...

1.  Given the data below, design IA-32 instructions to copy data in array X to array Y.   .data X   sdword   10,30,40,-10,-20,-4,-50 Y   sdword   7 dup (?)    2.  Given

Determine the process of modelling, Determine the process of modelling ...

Determine the process of modelling The process of modelling is much easier, if mathematical description of an object, or at least of part of an object may be applied. In the fi

Determine the flow rate - material balances, 1. A continuous steady-state p...

1. A continuous steady-state process involving components A, B, and C is shown below, along with the known process information a) On the flowchart, assign variables for the unkn

Discuss relative demerits and merits of belt, Discuss relative demerits and...

Discuss relative demerits and merits of belt, rope and chain drive for transmission of power and find the condition for transmitting the maximum power in a flat belt drive.

Maximum shear stress and angle of twist, Maximum shear stress and angle of ...

Maximum shear stress and angle of twist: Torques are applied on the shaft as illustrated in Figure. Discover in which portion of the shaft, maximum shear stress & angle of twi

Form tool design, I want to make a form tool for lathe for making a convex ...

I want to make a form tool for lathe for making a convex groove of 3 mm radius. tool material will be tungsten carbide. I want to know the dimensions of tool. What is the procedure

Seismometer-accelerometer-accelerometer, Seismometer : this is a transduc...

Seismometer : this is a transducer in which signal is proportional to the displacement. Accelerometer : This is a transducer in which signals is proportional to the a

Calculate the vertical anchoring forces, A converging elbow (see Figure 4) ...

A converging elbow (see Figure 4) turns water through an angle of 135 o in a vertical plane. The flow cross-section diameter is 400 mm at the elbow inlet, section (1), and 200 mm

Describe dry and wet parting materials, Q. Describe Dry and wet parting mat...

Q. Describe Dry and wet parting materials? Dry parting materials: These are applied by dusting. These include : charcoal, ground bone and limestone, lycopodium(a yellow veget

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd