Shielding gas advantages, Mechanical Engineering

SHIELDING GAS ADVANTAGES

 

Some of the advantages of GMAW process as compared to other arc welding process are as follows:

  • It is a continuous welding process and can be mechanised.
  • Welding can be done in all positions.
  • Higher welding speed.
  • Deeper penetration is possible, which permits the use of smaller size fillet welds for the equivalent strength.
  • Open arc nature of the process aids monitoring and control of the arc during welding.
  • Higher metal deposition rate.
  • Less distortion due to higher welding speed.
  • Avoids the chore of cleaning a solidified slag from the surface of each weld pass.
Posted Date: 9/17/2012 1:42:37 AM | Location : United States







Related Discussions:- Shielding gas advantages, Assignment Help, Ask Question on Shielding gas advantages, Get Answer, Expert's Help, Shielding gas advantages Discussions

Write discussion on Shielding gas advantages
Your posts are moderated
Related Questions
Explain POINT ANGLE - Angle of drills It is also known as a cutting angle. Its most commonly used value for a large variety of materials is 118.Though,its varies from 80 to 140

Spark Plug: A spark jumps between the electrodes of the spark plug when the voltage developed by the ignition system reaches the required value. This electrical spark occurs at a

How are fuels divided ? Write disadvantages and advantages of each types. (b) A sample of coal supplied to a boiler has the following composition by mass : Carbon = 88%, Hydr

A car travels at a constant speed around a circular track whose radius is 2.2 km. The car goes once around the track in 400 s. What is the magnitude of the centripetal acceleration

Conveyor and auger Two Hydraulic motors are provided for individual control of two conveyors and Auger, which are provided for individual control of material on both the sides

significance & relevance of lubrication

Kelvi n Plank Statement: Sol: It is impossible to construct this type of H.E. that operates on cyclic process and converts all the heat supplied to it into equivalent

an arrangement of the wilson epicyclic gearbox giving four forward and one reverse speed of shaft D for an input speed of shaft E is shown in fig .3.in 1st gear Ii is fixed.in 2 ge

A String LM long is tied to the ends of a uniform rod that weight 60 N and is 1.6m long. The string passes over a nail so that the rod hangs horizontally. Determine the tension in

Q. Explain Moulding Sand for Non-ferrous Casting? The melting point of non- ferrous metal is much lower than that of ferrous metals. Therefore, the moulding sands for non-ferr