Second Order Precesses, Electrical Engineering

A second-order process with one pole at the origin has the transfer function
3/(s(2s + 1))
Find the output as a function of time, for a unit step input change. Sketch the expected behavior.
Posted Date: 1/15/2013 12:43:54 PM | Location : United States







Related Discussions:- Second Order Precesses, Assignment Help, Ask Question on Second Order Precesses, Get Answer, Expert's Help, Second Order Precesses Discussions

Write discussion on Second Order Precesses
Your posts are moderated
Related Questions
Astigmation control: In most modern oscilloscopes there is an additional focusing control marked Astigmation . This is used to correct an effect which exactly is analogous to

Q. Obtain the truth table for the logic block shown in Figure

what is meant by pole changing methods in induction motor

Q. Explain about Junction FET? The JFET is a three-terminal, voltage-controlled current device, whereas the BJT is principally a three-terminal, current-controlled current devi

Circuit Symbols for MOSFET A range of symbols are employed for the MOSFET. The basic design is usually a line for the channel along with the source and drain leaving it at rig

8085 processor has 8 bit ALU (Arithmetic Logic Review). Likewise 8086 processor has 16 bit ALU.

Q. If a single phase motor fails to run or start slow what action to be taken. Ans: If it is not starting check the supply and test the winding if it found normal check

Q. The inductance per unit length in H/mfor parallel plate in?nitely long conductors in air is given by L = µ 0 d/w = 4π×10 -7 d/w, where d and w are inmeters.Compute L (per unit

Q. Advantages of subscriber loops signalling? (i) Information can be exchange between processors much more faster than when channel associated signalling is used. (ii) As a

explain all the components involved in transmission of electricity