Schedule evaluation, Mechanical Engineering

Schedule Evaluation

Each continuations of a partial schedule that are produced in step 1 are ranked as per to their respective cost function. This cost function might be dissimilar from the performance criteria since a cost has to be allocated to the partial completion of a job.

 

Posted Date: 3/5/2013 8:10:20 AM | Location : United States







Related Discussions:- Schedule evaluation, Assignment Help, Ask Question on Schedule evaluation, Get Answer, Expert's Help, Schedule evaluation Discussions

Write discussion on Schedule evaluation
Your posts are moderated
Related Questions
Q. Module Site Installation Preparation? The following tasks shall be accomplished at the Facility site prior to setting the modules on the piles: After module support piles

Calculate strength coefficient: A copper specimen of 64 mm gauge length and 12.80 mm dia. was tested in tension. Following two diameters were recorded in the plastic range of

A chemical works produces an aqueous effluent at above ambient temperature. The Environmental Agency insists that before the effluent is discharged to the river, it must be cooled.

Q. What do you understand by Carburization? Carburization is initiated by the adsorption of carbon in contact with the surface of the metal and may progress by diffusion along

I have three assignment in Supply Chain Engineering. It is a Games assignment in: 1- Beer Game 2000 words. 2- Risk Pooling Game, Object of this game is to rewrite properly correct

a) Show that if E is assumed to be correctly calculated, an error of 1% in the evaluation of C will involve an error of about 6% in the determine of Poisson's ratio when its correc

Working of Reaction turbine: In the impulse turbine the steam is expanded, causing pressure and heat drop in nozzle only and the moving blades only direct the steam through an

Water flows into the sink shown in figure 5 at a flow rate of 8 L/min. If the drain is closed, the water will eventually flow through the overflow drain holes rather than over the

Advantages of resistance welding   1. Resistance welding is very fast compared to arc welding. 2. Almost any combination of metals can be resistance welded provided necessa

(a) Draw P-H and T-S diagrams for following cases : (3) (i) Cycle with superheated vapour before compression. (ii) Cycle with sub-cooling or under-cooling of refrigerant.