Sbb instruction , Electrical Engineering

SBB Instruction

This  instruction is used to subtract the contents of register  or memory  location  with carry  flag from accumulation. The results  of operations is stored  in the  accumulator. There are two  formats.

Posted Date: 4/4/2013 7:16:38 AM | Location : United States







Related Discussions:- Sbb instruction , Assignment Help, Ask Question on Sbb instruction , Get Answer, Expert's Help, Sbb instruction Discussions

Write discussion on Sbb instruction
Your posts are moderated
Related Questions
Control Strategies Equation shows  that output  voltage V0 can be controlled through α and this duty cycle  α can be varied by various  strategies which are as follows.

Which clipper would you prefer between the series and the shunt clipper? Why?

Classify the materials based on the energy bands and explain them. Classification of materials based on energy bands: With reference to various band structures demonstrate

Q. Explain digital frequency meter. or Explain principle of digital frequency meter and discuss utility of time base selector with suitable diagrams. Sol. Digital Fr

Explain LOOP instructions in 8086 family with example and their effect on flag. LOOP: (Jump to given label until CX = 0) it is used to repeat a sequence of instructions for

Q. Elucidate the process of inter-register signalling. Ans: Registers are used in common control exchanges to store as well as analyze routing data. They are provided on a

Q. What do you mean by Common collector configuration? Common collector configuration:In this circuit the collector is common to both the input and the output.Such a configurat

The one line diagram of a simple three-bus power system is shown in the figure below.  Each generator is represented by an emf behind the transient reactance.  All impedances are e

Q. Determine v, i, and the power delivered to elements in the network given in Figure. Check whether conservation of power is satisfied by the circuit.

Status Signals There are three status  signals IO/M s and s 1 . All  these  signals  are output  signals. IO/ M - it is a status  signals  used to distinguish  whether  the