Role of rebate in typical construction joint, Civil Engineering

Assignment Help:

Question
What is role of rebate in typical construction joint?

Answer
Construction joints are formed on sites to facilitate construction procedure. Though, if improperly constructed, completed construction joints determination leave an uneven scar on concrete surface and change significantly its exterior. To avoid this, a rebate is formed throughout first pour of one side of construction common. After other pour is concreted, it will hide uneven joint inside rebate.


Related Discussions:- Role of rebate in typical construction joint

Shear stress, shear stress numerical of T section & I section to find maxim...

shear stress numerical of T section & I section to find maximum shear stress

Raking piles of bridge abutment placed under an embankment, Question It sho...

Question It should be necessary that raking piles of a bridge abutment be placed under an embankment ? Answer For a bridge abutment to be supported on raking piles with div

Design the 2-span continuous center, Design the 2-span continuous center T-...

Design the 2-span continuous center T-beam, B2, for the floor syetem shown below. The girders that the beam frames into are all 24" wide. Using fc'= 5 ksi, and fy = 60 ksi. The ser

Engineering mathamatics, #question.A strain gauge arrangement is used to me...

#question.A strain gauge arrangement is used to measure the applied force of a comnplex shaped civil engineering structure. Theoretical analysis have been round the relationship be

Mr Kamal Saxena, What is WBM road. How it is constructed?

What is WBM road. How it is constructed?

State the importance of structural element, State the importance of structu...

State the importance of structural element If this structural element is used as a beam element, subjected to self load and other imposed transverse loads, then the bottom fibr

Determine the liquidity index and void ratio of the sample, A piece of clay...

A piece of clay taken from a sampling tube has a wet weight of 1.553 N and volume of 95.3 cm . After drying in an oven for 24 hours at 105°C, its weight is 1.087 N. The liquid and

Test for determination of uitimate compressive strength, Q. Test for determ...

Q. Test for determination of Ultimate Compressive Strength The test pieces are to be loaded either till the failure of the steel laiminate or till the irreversible squeezing ou

Determine about the lee-mccall system, Determine about the Lee-McCall syste...

Determine about the Lee-McCall system In the Lee-McCall system, high-tensile strength bars of diameter varying from 12 to 40 rnrn are used as tendons. These bars are threaded a

Glazed tiles for construction material, Q. Glazed tiles for Construction Ma...

Q. Glazed tiles for Construction Material? Glazed tiles are only meant for dadoes of bath room, Toilet and kitchens etc as they have no strength . Normally 8'' x 4'' g

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd