resistance, Electrical Engineering

if the sheet resistance of a tin oxide is 100 ohms, what is the thickness of the oxide layer?
Posted Date: 2/27/2013 9:59:00 PM | Location : United States







Related Discussions:- resistance, Assignment Help, Ask Question on resistance, Get Answer, Expert's Help, resistance Discussions

Write discussion on resistance
Your posts are moderated
Related Questions
key performance indicators

A 3-phase, wye-connected, 11.8 kV, 100 MVA turbo- generator of 0.8 power factor lagging has a synchronous reactance of 2.0 p.u. on rating. The generator is driven by a steam turbin

ADI Add Immediate  Instruction The  bit  data specified in the instruction  is  directly  added with  contents of accumulator and result  of operation is stored  in the  accum

Q. A dc series motor operates at 750 r/min with a line current of 100 A from the 250-V mains. Its armature-circuit resistance is 0.15  and its series-field resistance is 0.1 . As

Q. Show Maximum Common-Mode Input Voltage of amplifier? This is the maximum voltage that the two inputs can be raised above ground potential before the op amp becomes nonlinear

explain a basic measurement system

Q. Show the familiar electric sources? Batteries and ac outlets are the familiar electric sources. These are voltage sources.An ideal voltage source is one whose terminal volta


Q. (a) Draw the logic diagram of the enabled D latch using only NAND gates. (b) Complete the timing diagram of Figure (a) of theDlatchwhose block diagram and truth table are giv

Determine the shaft power output: A 6-pole, 50 Hz, 3-phase induction motor running on full load develops a useful torque of 180 Nm when the rotor emf frequency is 2 Hz. Determ