Remote-load latency problem, Computer Engineering

Remote-load Latency Problem: When one processor requires some remote loading of data by other nodes, then the processor need to wait for these two remote load operations. The longer the time taken in remote loading, the larger will be the latency and idle period of the issuing processor.

 

Posted Date: 3/4/2013 5:51:06 AM | Location : United States







Related Discussions:- Remote-load latency problem, Assignment Help, Ask Question on Remote-load latency problem, Get Answer, Expert's Help, Remote-load latency problem Discussions

Write discussion on Remote-load latency problem
Your posts are moderated
Related Questions
What are the Features of CISC Processors The standard features of CISC processors are listed below:  CISC chips have a large amount of dissimilar and complex instructions.

What is the maximum number of fragments that can result from a single IP Datagram? Explain. To fragment a datagram for transmission across a network, a router utilizes the netw

What is Fish Bone Diagram? Or Explain Ishikawa Diagram. Fish Bone Diagram is also known as Ishikawa Diagram or Cause and Effect Diagram. It is known as Fish Bone Diagram be

What is a system call? A  system  call  is  a  request  made  through  any  program  to  the  operating  system  for performing tasks, picked by a predefined set, that the said

Memory - management mode System memory-management mode (SMM) is on the same level as protected mode, real mode and virtual mode though it is provided to function as a manager

1. Use the Web Site Scan verification point to check the content of your Web site with each revision and make sure that changes have not resulted in defects. 2. Use the Web Sit

Define word length?  Every group of n bits is referred to as a word of information and n is known as the word length.


What is the greatest benefit of using asp.net mvc over asp.net webforms? Ans) It is complex to unit test UI with webforms, where views in mvc can be very simply unit tested.

DRAM consists of MOSFET's but the technique is to use the drain source capacitance to hold charge. If charge is present logic '1' is held, no charge logic '0'. As you know capacito