Reed solomon code, engineering, Other Engineering

i have created simulink model for rs code with overlapped symbol and without overlapped symbol.
and BIT ERROR RATE VERSUS EB/NO PLOT is observed for its performance analysis.but i get same plot for both model.

i have used circular shift but may be it is not working properly.
so please do needful for this.

also i have to do iterative decoding of with overlappped symbol which is explained in paper.
but according to reference paper i cant connect as shown in fig.4 and fig.6 of paper with overlapped symbol.
Posted Date: 2/29/2012 5:48:44 AM | Location : United States







Related Discussions:- Reed solomon code, engineering, Assignment Help, Ask Question on Reed solomon code, engineering, Get Answer, Expert's Help, Reed solomon code, engineering Discussions

Write discussion on Reed solomon code, engineering
Your posts are moderated
Related Questions

Q.5 Explain briefly the Blending of metal powders. Ans. Blending of Metal Powder:              The procedure of blending (mixing) powders is taken out for the followi

Vibration Analysis Gas turbine engines have extremely low levels of vibration compared to piston engines. Changes in vibration levels could occur therefore without being notic

Application of Vector and Scalar quantities in Vector Analysis subject

ELECTRICAL DE-ICING SYSTEM MAINTENANCE: Tests of the system must be carried out when the servicing schedule required it or when a component has been replaced.  Typical tests ar

Equivalent Shaft Horsepower (EHP) In practice there is always a certain amount of jet thrust in the total output of the turbo-propeller engine and this must be added to the s.h

Extrusion : In this method of forging, the metal slug is forced to pass through a die under the action of intense of hydraulic pressure. The process can be viewed as squeezing the


Approach The Hanley solver does solve for the boundary layer and potential flow (in a way we will think about later). However, it only gives us full access to the potential solu

Which range will you select when measuring for 240ohms resistor?