Procedure-design and features of a laboratory, Chemical Engineering

Assignment Help:

PROCEDURE : Visit any lab (physics, chemistry or biology) of your study centre or any other you can get access to and note its features. To guide you through we have listed below the main features along with some hints so that you can examine it in a systematic way and do not miss out something essential. If we have forgotten something that you consider important, you should add to the list.

You are expected to observe the features, and make your comments and suggestions keeping in view what you learnt here of LT-1 course.

 


Related Discussions:- Procedure-design and features of a laboratory

Refractory, application of neutral refractory

application of neutral refractory

THIN LAYER CHROMATOGRAPHY, how do you prepare and use preparatory thin lay...

how do you prepare and use preparatory thin layer chromatography plates

The total entropy change, The similar system is now heated in two stages, ...

The similar system is now heated in two stages, by rst contacting with a reservoir at T2 halfway among T1 and Tf , then by contacting with the reservoir at Tf . Again and the ent

ASSIGHMENT, how nickel is incearing the toughness of steel?

how nickel is incearing the toughness of steel?

Process of annealing, What are the objectives of annealing? Annealing ...

What are the objectives of annealing? Annealing , is a heat treatment where in a material is altered, causing alters in its properties like as strength and hardness. It is a p

Heat transfer coefficient for the forced convection , A) A horizontal tube ...

A) A horizontal tube having a 1.25 cm outside diameter is submerged in a water 1 atm and 100 oC. Determine the heat flux for the surface temperature of (a) 540 o C, (b) 650 o C,

Give the properties and applications of teflon, Give the properties and app...

Give the properties and applications of Teflon. Teflon: This is acquired by the polymerisation of tetrafloourethylene. Properties: 1. This has good electrical, therma

Introduction to classifying and handling of hazardous , INTRODUCTION : You...

INTRODUCTION : You have studied about chemical hazards in Unit 13 of Block-3 and would have learnt that many chemicals are hazardous. A good practice is to exercise caution in han

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd