Power supply and cpu bus, Computer Networking

CPU bus

It is connect with various components of the system and  transformation of data between components.  

Power Supply

It is separate  external part of cisco router. Cisco 2600 DC Series Modular Access Platform series to Service Provider of  main agent and Data Communications Networks.Chasis option is available in cisco 2600 series. Most DC series version  support one NM module,two WIC slots, one AIM slots,two  LAN ports ,  one asynchronous auxillary port and  one console port.

 The PWR600-AC-RPS(Redundant Power Supply) is also additional spare AC  power supply for router

RPS for the 2600 Series routers. This power system deals with LAN and WAN products by MTBF mode. Suppose if power supply in the hub fails, hub and switch restarted and work again with the help of RPS. Local and remote monitoring status are also supported by RPS.


Posted Date: 3/5/2013 7:01:33 AM | Location : United States

Related Discussions:- Power supply and cpu bus, Assignment Help, Ask Question on Power supply and cpu bus, Get Answer, Expert's Help, Power supply and cpu bus Discussions

Write discussion on Power supply and cpu bus
Your posts are moderated
Related Questions
Commands SMTP uses commands  and response  to transfer  message between a client  and a  server.  Each  commands  or reply  is terminated by a two character ( carriage re

Q. Which steps are used at receiver end by check sum? The receiver follows these steps: The unit is divided into "k" sections each of "n" bits All sections are

In IPSec what is SAD, SPD and SA's?

What is virtual channel? Virtual channel is normally a connection from one source to one destination, although multicast connections are also allowed. The other name for virtua

Ethernet Addressing Every station on the network must have a unique physical address Offered by a six-byte physical address encoded on the network interface card (NIC)

Header  length This  field  specifies the  length of the TCP header  in 32 bit  words. This  information  allows  the receiver to know  the beginning of the data area becau

what role would you assign for Pentium iii, 500 MHz processor, 256 MB memory, 1o GB hard drive

There are three building blocks of client/server a) The client   b) The server and   c)  Middleware.