piping, Mechanical Engineering

I have an assignment and i want you to do it for me
Posted Date: 12/3/2012 3:45:19 PM | Location : Canada







Related Discussions:- piping, Assignment Help, Ask Question on piping, Get Answer, Expert's Help, piping Discussions

Write discussion on piping
Your posts are moderated
Related Questions
Design the keys - Shear Keys: A solid circular shaft is to transmit 200 kN at 200 rpm. If the maximum shear stress is not to exceed 80 n/mm 2 design the shaft. Design the key

Hi. I have made a payment for the above ticket number. Will I get all the workings out too? kenadams154@yahoo.co.uk

Alignment of a Railway Line: Selection of Alignment The following points must be considered in selecting the alignment of a railway line : (a) It should be as direct

At site locations, the WorleyParsons QC Specialist (QCS) is responsible to verify that the requirements for PMI as specified in the purchase order/subcontract documents are impleme

Q. Minimal external force required to achieve alignment? Minimal external force shall be applied to achieve alignment. Flanged joints not conforming to the dimensional toleranc

Q. Show Bolt Material? Bolt material must be selected with adequate yield strength at the operating temperature to provide the required strength to properly seat the gasket. It

DESIGN FACT DATA: ?A) Torque capacity for traction motor of screw conveyor-1660 N-m. ? B) RPM of Traction motor-115 rpm. ? C) Pressure require for operating the telescopi

An air refrigerator operates between the pressure limits of 1 bar and 5 bar. The temperature of the air entering the compressor and expansion cylinder are 15 o C and 25 o C respect

A truss of span 10 meters is loaded as shown in Figure. Determine the forces in all the members of the truss by Method of Joint.

Expression for the maximum shearing stress: Obtain expression for the maximum shearing stress and maximum shearing planes. Sol.: The condition for maximum shearing stress i