Pattern practices, Other Engineering

Pattern Practices : A pattern may be defined as a replica or fascimile model of the desired casting which, when packed or embedded in a appropriate moulding material, creates a cavity known as mould.

Posted Date: 8/3/2012 1:14:18 AM | Location : United States

Related Discussions:- Pattern practices, Assignment Help, Ask Question on Pattern practices, Get Answer, Expert's Help, Pattern practices Discussions

Write discussion on Pattern practices
Your posts are moderated
Related Questions
Logic gates - and gate: Figure shows the symbol that represents 2 input AND gate together with its truth table. This gate will only adopt a 1 state at its output terminal when

Q. Describe briefly the following methods of forging :        (i) Drop forging        (ii) press forging Ans.  (i) Drop Forging: It is also called die

When a beam of monochromatic x ray is incident on a graphite block, it get scattered and scattered wavelength is larger than that of the incident radiation wavelength. This scatter

Q. What is slip? What is slip plane? What are principal if slip planes and slip direction for BCC, FCC and HCP crystal? Ans. X-ray diffraction studies show that the crystalli

what is explicit conceptual model in SE

an iron ring with amean dia of 50 cm has an air gap of 1mm awinding of 200 turns if the permeability of the iron is 400 when a circuit of 1.25A flows through the coil find the flux

can u give idea about project in agriculture

Lifting wing FP was run at the conditions corresponding to AGARD WG07 TEST CASE 11, namely M∞ = 0.84,α= 3.06 deg. The ‘final step' values of the partially-conservative paramete

Piezoelectric Accelerometer Piezoelectric accelerometers are widely used for vibration measurements due to their low cost and very wide frequency range for which the sensitivit