Objectives-object-oriented control architecture , Mechanical Engineering

Assignment Help:

Objectives

After studying this section, you should be capable to understand:

  • Cell control and modeling,
  • Context level data flow diagram,
  • A common cell control system, and
  • Object-oriented program and cell controlled class architecture.

 


Related Discussions:- Objectives-object-oriented control architecture

Intermittent motion, Intermittent motion Most seam welding machine requ...

Intermittent motion Most seam welding machine requirements are met by the use of continuous drive. However, in cases where heavy work parts are to be welded or more than a sing

Acceleration of the two blocks, In the drawing, the weight of the block on ...

In the drawing, the weight of the block on the table is 380 N and that of the hanging block is 215 N. Ignore all frictional effects, and assuming the pulley to be massless.

Structural steels, Structural Steels Low alloy steels are utilized fo...

Structural Steels Low alloy steels are utilized for structural causes. That type of steels is needed to possess high yield stress, excellent ductility and high fatigue resist

Assignemnt , A heating section consists of a 10 in diameter duct which hous...

A heating section consists of a 10 in diameter duct which houses a 8 kW electric resistance heater. Air enters the heating section at 14.7 psia 40oF, and 35 percent relative humidi

Heat transfer and temperature distribution, Derive the mathematical express...

Derive the mathematical expression for heat transfer and temperature distribution through infinite long fin?

Estimate the weight of the casting, Estimate the Weight of the Casting ...

Estimate the Weight of the Casting A Yoke casting shown in Figure is to be produced by sand casting process. Estimate the weight of the casting if the density of the material

Formation - permanent way, Formation (Embankment): The formation is t...

Formation (Embankment): The formation is the earthen embankment on which the other components of the track rest. For supporting the heavy loads, the earth should be of good q

Creep, Creep in belt drive

Creep in belt drive

Submerged arc welding, Submerged Arc Welding   Single pass filler we...

Submerged Arc Welding   Single pass filler welds upto (8.0 mm) maximum and groove welds made with a single pass or a single pass each side, may be made using an E7os-x elect

By ansys finite element discuss the states of stress, A loaded structural c...

A loaded structural component, shown in Fig Q7, is manufactured from sheet steel having a Young's modulus, E = 208000 MPa and a Poisson's ratio, n = 0.3. The sheet steel is 2 mm th

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd