## MOS., Mechanical Engineering

Assignment Help:
WHY SHEAR STRESS IS NOT MAXIMUM AT THE NEUTRAL AXIS IN TRIANGLE...ITS MAX IN ALL OTHER CASES BUT Y NOT IN TRIANGLE?#

#### Give the expression for inductance., Q.   Give the expression for inductan...

Q.   Give the expression for inductance of a ? N ?    turn coil wound on a core having length I cross - sectional area A and magnetic permeability µ. Explain the significance of

#### Induction machine operation, Induction Machine Operation For operation ...

Induction Machine Operation For operation with rated L-L voltage of 230 V and rated frequency of 60 Hz, the performance of a particular 10 hp machine at its rated speed and pow

#### Mechanics, definition of open and cross belt drive

definition of open and cross belt drive

#### Bending stresses, Determine: Reaction forces at the supports The shear an...

Determine: Reaction forces at the supports The shear and moment diagrams The location and value of the maximum shear and moment The cross section is an angle section as given in

#### Find the inner diameter of the tubular steel shaft, Find the inner diameter...

Find the inner diameter of the tubular steel shaft: A solid aluminium shaft having 1 m long & of 50 mm diameter is to be replaced by a tubular steel shaft of the similar lengt

#### What is the make group of euler operators, The Make Group of Euler Operator...

The Make Group of Euler Operators The Make group consists of four operators for adding some elements into the existing model creating a new one, and a Make-Kill operator for ad

#### Calculate the radius of plates, Calculate the radius of plates: A lami...

Calculate the radius of plates: A laminated steel spring, simply supported at the ends & centrally loaded, along a span of 0.8 m; is needed to carry a proof load of 8 kN; and

#### Describe the working of a four stroke petrol engine, a) Describe main advan...

a) Describe main advantages and disadvantages of CI engine as compared to SI engine. b) With the help of a neat diagram, describe the working of a four stroke petrol engine.

#### Engineering design, 1) State five factors that must be considered when choo...

1) State five factors that must be considered when choosing a material. Discuss the importance to the engineer of each of these factors. 2) An engineer is planning to design a s

#### Typical joint designs used in electron beam welding, TYPICAL JOINT DESIGNS ...

TYPICAL JOINT DESIGNS THAT ARE USED IN ELECTRON BEAM WELDING Butt joint : Butt joint is the preferred joint as it involves only a small amount of machining prior to wel