Measurement of hardenability, Mechanical Engineering

Measurement of Hardenability:

Two testing techniques have been enhancement to measure the harden-ability of steels. The first, termed as cylinder series test, offers a single value of harden-ability. The value is stated in terms of martensite of percentage at the centre while quenched in a specific manner. The second, termed as Jominy and quench test results in a curve.

Posted Date: 2/26/2013 5:48:39 AM | Location : United States







Related Discussions:- Measurement of hardenability, Assignment Help, Ask Question on Measurement of hardenability, Get Answer, Expert's Help, Measurement of hardenability Discussions

Write discussion on Measurement of hardenability
Your posts are moderated
Related Questions
Q. Define the project scope? The Design Basis Memorandum defines the project scope. This includes basic design concepts and the basis and philosophies upon which the project s

Write down the uses of following tools and make neat sketches of the same : (a) Vernier Caliper (b) Steel Rule

Low Hydrogen Electrodes Low hydrogen electrodes are so called because their covering is low in hydrogen bearing compounds and only traces of hydrogen or moisture are present in t

(a) What is the function of a clutch in an automobile? Illustrate the principle of friction clutches with the help of neat diagrams. (b) Discuss the working and construction of

How is bearing capacity of soil varied? The bearing capacity of soil varies not only with its strength but also with the magnitude and distribution of the load. When a load Q,

Find the speed of shaft : Find the speed of shaft driven with the belt by an engine running at 600 rotation per minute. The thickness of belt is 2cm, diameter of engine pulle

Assume we want to determine the minimum stopping distance of an automobile traveling at 60 mph. We again assume that the maximum value of ยต is unity. Then the maximum deceleration

Voltage: The voltage is the potential difference between two points. The current flows from higher potential to lower potential. Voltage is measured in volts (V). V = IR

Calculations for force: A square block having 25cm side and weighing 20N is hinged at point A and rests on rollers at point B as shown in the figure given below. It is pu