Logical operations , Electrical Engineering

Logical Operations

Various  operations like and  or exclusive  or complement compare and rotate are called  logical  operations. Generally flags ( not all always) are modified in all these  operation except complement  operation, in which no  flag is  modified.

The readers are  advised to read carefully about  various flags  for each instruction.

Posted Date: 4/5/2013 12:33:22 AM | Location : United States







Related Discussions:- Logical operations , Assignment Help, Ask Question on Logical operations , Get Answer, Expert's Help, Logical operations Discussions

Write discussion on Logical operations
Your posts are moderated
Related Questions
If the message has a spectrum where K and Wf are positive constants, sketch the spectrum of a standard AM signal that uses the message. Comment on the physical signi?cance

Q. Which are the different FET amplifiers? A FET can be used as a small-signal amplifier by connecting one of its lead to signal ground. The other two leads then serve as the i

Q. What is Traffic Engineering? Traffic engineering provides the foundation for analysis and design of telecommunication network to carry a given traffic at a particular loss p

Mutual inductance and coefficient of coupling: The equivalent inductance of two series connected coil (with mutual inductance among them) is 0.8 or 0.2 Henry based on the rela

Determine the equivalent inductance: Two coils of inductances 4H and 6H are connected in parallel. If their mutual inductance is 3 H, determine the equivalent inductance of th

For the amplifier circuit shown below estimate the mid band voltage gain if the EARLY voltage (V A ) of the current mirror transistors is 80 volts.  Assume the d.c biasing is optim

Error-Rate Control, Output-Rate Control, and Integral-Error (Reset) Control Let us consider a typical second-order servomechanism(containing two energy-storing elements) whose

Q. If the line of Problem 15.1.3 is made of copper whose resistivity ρ = 1.72×10 -8 ·m, determine the maximum length that can be used if losses are not to exceed 3 dB when f = 3

disadvantages of shunt&series clippers

Name the materials used in case of Bimetals and give reasons. Bimetals : Alloy of nickel and iron along with low value of coefficient of thermal expansion are utilized as