Ldax load accumulator indirect instruction , Electrical Engineering

LDAX  Load Accumulator Indirect Instruction

This instruction is used to copy data  from memory  location pointed by register  pair only  BC or DE  to the accumulator  HL pair cannot  be used in this  instruction. The  instruction format is .

LDAX Rp (A - [RP])

 

Posted Date: 4/4/2013 5:41:26 AM | Location : United States







Related Discussions:- Ldax load accumulator indirect instruction , Assignment Help, Ask Question on Ldax load accumulator indirect instruction , Get Answer, Expert's Help, Ldax load accumulator indirect instruction Discussions

Write discussion on Ldax load accumulator indirect instruction
Your posts are moderated
Related Questions
what is experimental setup for Butterworth filter?

Q. What is Trans conductance? It is ratio of small change in drain current to the corresponding change in the gate-to-source voltage for a constant gate-to-source voltage .it i

Q. What is a darlington pair?                             The Darlington circuit consists of two cascaded emitter followers with infinite emitter resistance in the first stage.

Control  Bus The control  bus comprises of various  single  lines that carry  various  control  signals for synchronizing  various devices  and performing different task. The m

A three-phase, four-pole, 220-V, 60-Hz induction machine with a per-phase resistance of 0.5  is operating at rated voltage as a generator at a slip of -0.04, delivering 12 A of li

Electronic voltage regulators: Electronic voltage regulators operate through comparing the actual output voltage to a few internal fixed reference voltages. Any type of differ

A synchronous motor has the following parameters per phase. E=2kv, Eo=5kv, X2=3ohms, and I=700amps. Draw the phasor diagram and determine (a) power angle delta, (b) active po

Q. Do the following operations with 8 bit bytes, and indicate the condition of the overflow and carry bits. a) 10111011 + 00000011 b) 11101101 + 11111001 c) 11011011 + 110

Theft or Pilferage of Power by the Existing Customers Power theft through the existing consumers is the predominant cause of loss of revenue to the electrical utilities. Almos

Explain the effect of temperature on the resistivity of conducting materials. The resistance of most metals rises with rise of temperature whereas that of semiconductors and el