Laser surface treatment applications, Mechanical Engineering

LASER SURFACE TREATMENT APPLICATIONS

 

The laser can be used to alter the surface structure of materials either with or without alloying additions as compared to alloying by any other fusion welding or other surface modification technique. Without alloying additions, the processes include:

  • a) Transformation hardening: without surface melting.
  • b) Surface melting: producing homogenisation and rapid solidification structures.
  • c) Glazing: fast quench on certain alloys causes solidification of glass structure.
Posted Date: 9/17/2012 8:28:51 AM | Location : United States







Related Discussions:- Laser surface treatment applications, Assignment Help, Ask Question on Laser surface treatment applications, Get Answer, Expert's Help, Laser surface treatment applications Discussions

Write discussion on Laser surface treatment applications
Your posts are moderated
Related Questions
The cockpit of a jet plane flying at a speed of 1200 km/hr is to be cooled by simple air cooling system. The cockpit is to be maintained at 25 0 C and pressure in the cockpit is 1

The layout of a transmission shaft carrying two pulley C and B and supported on bearings A and D is shown in figure. Power is supplied to the shaft by means of vertical belt on pul

diameter = 100mm length = 470mm power = 4000 w radians = 78 shear modulus 60000 n/mm^2 determin the maximum shear stress and angle of twist

Design Problem:  Design a pipeline and pump station to pump 100 MGD of water to the Mississippi river.  To reduce the required horsepower of the pumps, the flow will be pressurized

There are various methods to visualize the design process which can be summarized as given below: a. An automated drafting tool and presentation of graphics. b. A means

Control Cables: Never bend or distort control cables. This will lead to stiff operation and premature cable failure. Rubber Parts: Beware of parts containing O-rings or oil s

Q. Identification of Defects of coating? All holidays and other coating defects, including without limitation primer blister, excess powder mounds, crazed coating, lifted and u

What are various types of damping ? Explain viscous damping. A vibrating system is defined by the following parameters : m = 4Kg, K = 10N/m, C =3N-Sec/m Evaluate (a) Na

Design a hydrocooling unit that can cool fruits and vegetables from 30 to 5 degrees Celsius at a rate of 20,000 kg/hr under the following conditions: The unit will be of flood typ

Q. Explain about Surface Preparation? All oil, grease, salts, and any other contaminants detrimental to the formation of a good coating bond or coating quality must be removed