Is codes for building materials and construction, Civil Engineering

IS CODES FOR BUILDING MATERIALS AND CONSTRUCTION

The following is the list of some of the IS code giving requirements for building materials: IS 269-1989. Specification for ordinary portland cement.

IS 455-1989. Specification for portland slag cement.

IS 516-1959.  Method of tests for strength of concrete.

IS 1123-1975. Method of recognition of natural building stones.

IS 383-1970. Specifications for fine and coarse aggregates.

IS 432-1982. Specification for mild steel.

IS 3495-1976. Gives specifications for building bricks.

IS 287-1973. Gives maximum permissible moisture content in timber for different uses and for different zone.

Posted Date: 10/22/2012 6:26:13 AM | Location : United States







Related Discussions:- Is codes for building materials and construction, Assignment Help, Ask Question on Is codes for building materials and construction, Get Answer, Expert's Help, Is codes for building materials and construction Discussions

Write discussion on Is codes for building materials and construction
Your posts are moderated
Related Questions
Explain Sedimentation 1. Sedimentation basin or clarifier is used to remove particles that will settle in a reasonable time period 2. Basins are usually rectangular or

Construction: Construction is usually done by one of the three methods: (a) Manual method, providing steel or wooden forms, pouring concrete and compacting by means of nee

Define Non-destructive inspection of Concrete Substructures? If there is evidence of significant deterioration, then a Level III inspection, involving either non-destructive or

Acidity and Alkalinity - Chemical Characteristics of Water Acidity: Capacity to neutralize bases and is a measure of acids in water. Acidity is measured by titrating the s

Design of Flexible Pavements: The design of flexible pavements is done by the CBR method. The CBR test, described further, gives an indication of the supporting power of the

Details of a simply-supported beam are given in Figures (a) and (b). Note that the dead load, g includes the self weight. Design the transverse shear reinforcement in ter

Explain Chezy Manning Equation v = 1.49/n (R) 0.67 (S) 0.5     R = hydraulic radius (ft) = Area/ wetted perimeter, R = D/4 for circular channels full and one-half full

Question What is major disparity between fasteners , bolts and screws ? Answer Fastener is a broad term to explain something that is used as a restraint for holding

Explain the Hydraulic Gradient A measurement of the movement of water over distances. Change in hydraulic head from one monitoring point to another.  i = ΔH/L  units are typ

Characteristics of couple #Minimum 150 words accepted#