Inspection and testing of vessels, Mechanical Engineering

Assignment Help:

Q. Inspection and testing of vessels?

The Vendor shall be responsible for all inspection and testing. WorleyParsons reserves the right to inspect vessels or parts of vessels at any time during fabrication to ensure that materials and workmanship are in accordance with the governing Code(s) and this Specification.

All pressure vessels shall be stamped (U1 or U2) in accordance with the requirements of the ASME Code, unless specified otherwise by WorleyParsons.

Vessels manufactured outside of Canada shall be registered with the ‘National Board of Pressure Vessels'.

All vessel materials, including attachments thereto, shall have traceability.

When specified in the Purchase Order, Positive Material Identification (PMI) shall be carried out in compliance with Specification GS902.07.

The Vendor shall provide a detailed Inspection and Test Plan (ITP) for each vessel. The ITP shall include all manufacturing, fabrication and inspection steps and sequences, for review and approval. A typical ‘Jurisdictional Travel Sheet' is not an acceptable substitute, without prior approval.


Related Discussions:- Inspection and testing of vessels

Two-or-three-dimensional-motion, Net force acting on particle of mass 2 kg ...

Net force acting on particle of mass 2 kg is 10N in north direction.At t=o, particle was moving eastwards with 10m/s. Find displacement and velocity of particle after 2 seconds.

Wet h2s corrosion, There is risk of wet H 2 S corrosion in all emulsion and...

There is risk of wet H 2 S corrosion in all emulsion and gas lines from the Inlet Separator up to and including the Treater. Full compliance to NACE is highly recommended to contro

Ventilation fan belt assembly, The aim of this assignment is for the studen...

The aim of this assignment is for the student to use the information, data and analysis techniques presented during lectures to design a belt drive transmission for a ventilation f

Determine the workdone by the fluid on the piston, Explain Zeroth law and 1...

Explain Zeroth law and 1 st law of thermodynamics. Describe Internal energy and Enthalpy. What is a PMMFK. Give the expression for reversible workdone in a thermodynamic system

Thermosetting plastics, Q. What do you mean by Thermosetting plastics? ...

Q. What do you mean by Thermosetting plastics? This plastic undergoes a number of chemical changes on heating and cure to infusible and practically insoluble articles. The chem

Determine the properties of foundation, Determine the Properties of founda...

Determine the Properties of foundation Soil profile together with natural type and properties of each strata will have a bearing on the choice of foundation. The fact that loa

Rankine Cycle, In a nuclear power plant saturated steam at 30 bar enters a ...

In a nuclear power plant saturated steam at 30 bar enters a h.p. turbine and expands isentrophically to a pressure at which its quality is 0.841. At this pressure the steam is pass

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd