Punches -tool and equipment , Mechanical Engineering

Assignment Help:

Punches

1584_punches.png Figure: Punches

A bar which carries a sharp point at one end and used to make a permanent mark on a part is called punch. The point is hard and tempered so that it can withstand against shocks. The bar can have different sizes and sections (Figure).

 

 

 


Related Discussions:- Punches -tool and equipment

Vacuum pressure and absolute pressure - thermodynamics, V acuu m (Or V...

V acuu m (Or Vacuum pressure) (P vacc ): It is pressure of fluid, which is always less than atmospheric pressure. Pressure in a steam condenser is one such examp

Determine the loss in fuel cost per hour, Give a neat and clean diagram of ...

Give a neat and clean diagram of Heavy water type "CANDU" nuclear power plant and illustrate its working. The incremental fuel costs for two generating units ‘a and b' of a powe

Electrical science, explain ways of representing alternative quantities;1)p...

explain ways of representing alternative quantities;1)phasor representation 2)graphical representation 3)complex waves 4)addition and subtraction of sine wave

Illustrate with required expression for hammer blow, Illustrate with requir...

Illustrate with required expression for Hammer Blow, Variation of tractive force, and Swaying Couple.

How to observe water level, Q. How to observe water level? Site for ins...

Q. How to observe water level? Site for installing gauges should be properly selected. The reach should be reasonably straight and of uniform cross· section and slope. The leng

Simple Mechanisms, I have an assignment on kinematic chains.I have to tell ...

I have an assignment on kinematic chains.I have to tell the type of chain whether it is locked,constrained or unconstrained?? I am facing problem in counting number of joints,pair

Explain the importance of hydraulic paver machine, Explain the importance o...

Explain the importance of Hydraulic paver machine In the center of the augers is a gear box. Kick back paddles are used to "tuck" mix under the gear box. If the paddles were n

Qualifications of welding procedures, Q. Qualifications of Welding Procedur...

Q. Qualifications of Welding Procedures? The Fabricator shall prepare and submit for review by Welding Procedure Specifications (WPS) and Procedure Qualification Records (PQR),

High temperature materials in boilers, Q. High temperature materials in Boi...

Q. High temperature materials in Boilers? A thin refractory layer between the shield and boiler tube is recommended in areas subject to moderate temperatures and levels of corr

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd