hh, Electrical Engineering

2+7
Posted Date: 10/24/2012 8:41:44 PM | Location : United States







Related Discussions:- hh, Assignment Help, Ask Question on hh, Get Answer, Expert's Help, hh Discussions

Write discussion on hh
Your posts are moderated
Related Questions
Q. What is Trans conductance? It is ratio of small change in drain current to the corresponding change in the gate-to-source voltage for a constant gate-to-source voltage .it i

Describe the physical properties and uses of the Brasses. Brass - It is an alloy of copper and zinc along with 60 percent copper and 40 percent zinc. Its properties are- 1.

CPU Based Exchange:   In centralized control, all control equipment is replaced by a single processor which should be quite powerful. It should be capable of processing 10 to 100 c

What is the main function of dummy coul in winding?

Q. A four-pole, lap-wound armature has 144 slots with two coil sides per slot, each coil having two turns. If the flux per pole is 20 mWb and the armature rotates at 720 r/min, cal

Give the significance of SIM and RIM instruction available in 8085. Instruction SIM: Set Interrupt Mask. This is a 1 byte instruction and can be used three dissimilar functio

Q. Illustrate Power Semiconductor Devices? Since the advent of the first thyristor or silicon-controlled rectifier (SCR) in 1957, tremendous advances have been made in power se

If an FM signal is given by s FM (t) = 100 cos [2πf c t +100 m(τ ) dτ ] and m(t) is given in figure, sketch the instantaneous frequency as a function of time and determine the pea

function of a commutator in a DC motor