Franklins Bells, Physics

(Assume the metallic ball is spherical with a diameter d = 2.5 cm. Let''s also
assume it is made out of nickel, which has a density of roughly 9 g/cm
3
.) After it first
touches the right-hand bell, the little ball will pick up some charge, which will spread
(pretty) uniformly over its entire surface. A reasonable number for the magnitude of
this charge would be about 0.03 ?C. Given these numbers, will the bell become
discharged if the ball touches it once or twice? Why or why not?
Posted Date: 9/10/2012 12:00:31 PM | Location : United States







Related Discussions:- Franklins Bells, Assignment Help, Ask Question on Franklins Bells, Get Answer, Expert's Help, Franklins Bells Discussions

Write discussion on Franklins Bells
Your posts are moderated
Related Questions
There is strong evidence that some short-duration gamma-ray bursts occur in systems with no star formation and where no massive stars are present, such as elliptical galaxies and g

Determine the real position of an air bubble in a glass cube of side 0.3m if the bubble seems to be at a distance of 0.05 m from one face and at 0.15m from the opposite face.

An iron wire has a cross-sectional area equal to 5.00×10-6m2. Carry out the following steps to determine the drift speed of the conduction electrons in the wire if it carries a cur

In the presence of electronic, ionic and dipolar polarization mechanisms, t he average induced  dipole moment per molecule will be the sum of all the contributions in terms of the

show that in a glass prism that the refractive index n = sin1/2(A+Dmin)/sin1/2A where a = refracting angle. hence if the angle of incidence i on oan air boundary is 60degrees. calc

Illustrate the working and principle of a nuclear reactor with the help of a labeled diagram?

Reducing friction with ball bearings  Find two tin cans that have a deep groove approximately the top, such as paint cans. Lay marbles in single groove and invert the other can

What is the difference between blow holes and porosity

The cantilevered beam below is supported at O.  F1 and F2 in kN are given in P21 and P22 respectively and act on the beam as shown.  Determine the magnitude and direction of a sing

A capacitor is to be constructed so that its capacitance is 0.2µF and to take a p.d. of 1.25kV across its terminals. The dielectric is to be mica which, after allowing a safet