Explain types of patterns, Mechanical Engineering

Assignment Help:

Types Of Patterns

There are various types of patterns depending upon the complexity of the job, the number of castings required and the moulding procedure adopted.

  • Single piece pattern
  • Split pattern or two piece pattern
  • Gated pattern
  • Cope and drag pattern
  • Match plate pattern
  • Loose piece pattern
  • Follow board pattern
  • Sweep pattern
  • Skeleton pattern

 

 

 


Related Discussions:- Explain types of patterns

Principal design criterion of plant layout, Q. Principal design criterion o...

Q. Principal design criterion of Plant layout? Safety-in-Design is a key factor associated with the layout design of any facility. The principal design criterion is to minimize

Sizing a Motor that has a cable Pulley, I am stumped as to how to figure th...

I am stumped as to how to figure this out. It is a motor with a cable pulley to move the carriage in a wave tank. (the part that pulls the boat, etc). I have to build it on paper

Evaluate the shear plane angle, In an orthogonal cutting process, following...

In an orthogonal cutting process, following data were taken. Chip length of 80mm was obtained with an uncut chip length of 200mm and the rake angle used was20 degrees and depth of

Determine the stresses in the shell, Determine the stresses in the shell: ...

Determine the stresses in the shell: A cylindrical boiler is 2.5 m in diameter and 20 mm in thickness and it carries steam at a pressure of 1.0 N/mm2. Determine the stresses i

#title.strengh of materials., What is the Ultimate Tensile Strength for alu...

What is the Ultimate Tensile Strength for aluminum in the SI Units?

Nitrides-silicides and sulfides, Nitrides, Silicides and Sulfides Nitr...

Nitrides, Silicides and Sulfides Nitrides contain very high melting point but initiate to oxidize at low temperature. They have poor resistance also to chemicals. Boron nitrid

Determine the compressor work, (a) A four cylinder engine operates at 1200 ...

(a) A four cylinder engine operates at 1200 rpm gave 18.6 KW brake power, the average torque when one cylinder was cut-off was 105 N-m. Evaluate the indicated thermal efficiency if

Determine the cutting ratio, Write the velocity relationship in orthogonal ...

Write the velocity relationship in orthogonal cutting. A bar of 75 mm dia. is reduced to 73 mm by a cutting tool while cutting orthogonally. If the mean length of cut chip is 73.5

Newton''s first law of motion - mechanics, Newton's first law of motion: ...

Newton's first law of motion: First law of Newton: It is magnitude of force that develops acceleration of 1 m/s2 in 1 kg mass of the body. The subject of rigid body mecha

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd