## Explain principle of design of jig and fixture, Mechanical Engineering

Assignment Help:

Explain Principle of Design of Jig and Fixture

While designing jigs and fixtures following considerations should kept in mind:

1. Reduction of idle time.
2. Rigidity should be in materials.
3. There is always clearance between jig and fixtures.
4. Clearance should be swarf.
5. Locating and supporting surfaces should be wherever possible be removable.
7. Clamping should always be arranged directly above the points supporting the work.
8. There are always provisions for the safety of designs.
9. Components should be ejected.
10. Jig bushes can be replaced whenever it worn out due to flowing out chips.

#### Governors, friction characteristics

friction characteristics

#### Age-hardening of aluminium alloys, Age-hardening of Aluminium Alloys I...

Age-hardening of Aluminium Alloys In specific alloys precipitation from a single phase may arise. The precipitate phase might be in form of determine sub-microscopic particles

#### #title.If your requirement is for a sensor suitable for a he, Ask question ...

Ask question #Minimum 100 words acceptedIf your requirement is for a sensor suitable for a heavy industrial application, with a linear characteristic, working in temperatures up to

#### Determine the deflection , Obtain the equations of the elastic curve and us...

Obtain the equations of the elastic curve and use them to determine the deflection and rotation at point B in terms of E, I, F and L.

#### Determine the maximum stress, The cross-section of two angles attached tog...

The cross-section of two angles attached together are shown on the left below. The properties of angles are given in the table with reference to the diagram on the right. The ma

#### Steady state energy, what do u you understand by steady state?

what do u you understand by steady state?

#### Organic chemistry, Production of hydrochloric acid

Production of hydrochloric acid

#### Calculate mass of the shoes, A centrifugal clutch is to be prepared to tran...

A centrifugal clutch is to be prepared to transmit 15 KW at 900 r.p.m. The shoes are four in number. The speed at which the engagement begins is 3/4 th of the running speed. The in

#### What is the function of fuel feed system?, (a) What is the function of fuel...

(a) What is the function of fuel feed system? (b) What are the functions of a carburettor? (c) List main components of a carburettor. (d) Describe the working principle of

#### What is the initial velocity of the ball, What is the initial velocity of t...

What is the initial velocity of the ball: A ball is horizontally thrown from the top of a building 60 m height, hits the horizontal ground 25 m from the base of the building a