Explain current divider rule, Electrical Engineering

Assignment Help:

Explain current divider rule

Current flow through at every resistor that connected by parallel can be find by using current divider rules (CDR). 


Related Discussions:- Explain current divider rule

Calculate the sending end voltage, A 150 km long, 3-phase, 400 kV overhead ...

A 150 km long, 3-phase, 400 kV overhead line is used to transmit 1800 MW to a distribution area at 0.9 power factor lagging. The line parameters per phase and per unit length in st

Show the interconnections and appropriate polarity markings, Q. Two 1150:11...

Q. Two 1150:115-V transformers are to be inter connected for (a) 2300:230-V operation, and (b) 1150:230-V operation. Show the interconnections and appropriate polarity markings.

How a nand gate decoder is used for 2716 eprom memory, With neat diagram in...

With neat diagram indicate how a simple NAND gate decoder is used to select a 2716 EPROM memory component for memory locations FF800H-FFFFFH. Simple NAND gate Decoder: As the 2

Electric machines, a shunt motor supplied at 230V rms runs at 900rev/min wh...

a shunt motor supplied at 230V rms runs at 900rev/min when the armature current is 30A.the resistance of the armature circuit is 0.4 ohms.find the armature input

What is transient program area, What is TPA (transient program area)? T...

What is TPA (transient program area)? The memory system is divided in three major parts: transient program area, System is and XMS that is extended memory system.

Characteristics of transformer, Q. Characteristics of Transformer? The ...

Q. Characteristics of Transformer? The characteristics of most interest to power engineers are voltage regulation and ef?ciency. The voltage regulation of a transformer is a me

Multiple tariff meters or tou meters, Multiple Tariff Meters or TOU Meters ...

Multiple Tariff Meters or TOU Meters Time of use metering facilitates load control and planning on the part of utilities. This is efficiently achieved using a concept known as

A, A microstrip antenna system operating at 915MHz must be designed using R...

A microstrip antenna system operating at 915MHz must be designed using Rogers RO3010 substrate with the thickness of 0.635mm.

Speed control of dc shunt motor - motor control , Speed Control of DC Shun...

Speed Control of DC Shunt Motor V dc   the output of rectifying circuit which is  applied to the motor field  as shown  in figure  for armature voltage V dc   is controlled by

List out the five categories of the 8085 instructions, List out the five ca...

List out the five categories of the 8085 instructions. Give examples of the instructions for each group. 1.  Data transfer group - MOV, MVI, LXI. 2.  Arithmetic group - ADD,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd