With the help of diagram , depict the evaluation of Machine Design.

Discuss in detail Technical feasibility, finanacial and economic feasibility, social and environmental feasibility.

How do you categarized materials for Engineering use? What are the factors to be taken for the selection of materials for design of machine elements?

Posted Date: 5/16/2013 4:08:14 AM | Location : United States

Ask an Expert

Related Discussions:- Evaluation of machine design, Assignment Help, Ask Question on Evaluation of machine design, Get Answer, Expert's Help, Evaluation of machine design Discussions

Write discussion on Evaluation of machine design
Your posts are moderated

Write your message here..

Related Questions

Points of contraflexure, Explain the points of contraflexure. Explain the points of contraflexure.

Define specific volume (v) of System, Define Specific Volume (v) It is ... Define Specific Volume (v) It is illustrated as volume occupied by the unit mass of the system. Its unit is m 3 /kg. Certain volume is reciprocal of density. ν = v/m; m 3 /k

Casting, defect of casting defect of casting

Bicycle frame design, You are required to design the central section of the... You are required to design the central section of the bicycle frame which consists of the seat tube, top tube, down tube and head tube. You can ignore the seat stays, chain stays a

Thermodynamic practical, temperature measurement by thermocouple temperature measurement by thermocouple

Welding procedure specification (wps)-variables, Variables used in WPS ... Variables used in WPS Depending on their influence on obtaining a desired weldment, the welding variables are then classified and listed. Some of them are listed as "Essential

Evaluate the stresses in the steel and concrete bars, A load of 2MN is appl... A load of 2MN is applied on a short concrete column 500 mm x 500 mm. The column is reinforced with four steel bars of 10 mm diameter, one in each corner. Evaluate the stresses in t

Brinell hardness test, what is static indentation and dynamic indentation? what is static indentation and dynamic indentation?

Find the magnitude and position of maximum bending moment, A simply support... A simply supported beam of length 5m takes a uniformly increasing load of 800 N/m at one end to 1600 N/m at the other end. Draw the shear force and the Bending moment diagrams for

Evaluation of the internal energy of steam - thermodynamics, Evaluatio n o... Evaluatio n of the Internal Energy of Steam: It is actual heat energy stored in steam above the freezing point of water. We know enthalpy = internal energy + pressure ener