Evaluate resultant force on the bucket, Mechanical Engineering

Assignment Help:

A single jet pelton wheel runs at 300 rpm under a head of 510 m. the jet diameter is 200m, its deflection inside the bucket is 165o and its relative velocity is reduced by 15% because of friction Evaluate :

(i) Water horse power.

(ii) Resultant force on the bucket.

(iii) Brake power if mechanical losses are 3% of power supplied, and overall efficiency.

Assume Kv (coefficient of velocity) 0.98 and Ku (speed ratio) 0.46.


Related Discussions:- Evaluate resultant force on the bucket

Fms, fms computer control system

fms computer control system

Natural frequency-degree of freedom-conservative system , Natural Frequency...

Natural Frequency: This is the frequency of vibration of a system that is undamped and without external excitation while it is disturbed. Forced Vibration: This is the vibra

Determine the resultant of the system of forces, Determine the resultant of...

Determine the resultant of the system of forces: Four forces act on a body as illustrated in Figure. Determine the resultant of the system of forces. Figure Sol

Determine the maximum uniformly distributed load, Determine the maximum uni...

Determine the maximum uniformly distributed load: A timber beam 150 mm wide & 300 mm deep is supported simply over a span of 4 m. determine the maximum uniformly distribute

Dislocation, Diff. B/w edge and screw dislocation

Diff. B/w edge and screw dislocation

COMPRESSOR PROBLEM FROM CUSTOMER, OUR CUSTOMER HAD APROBLEM WITH OUR CUSTO...

OUR CUSTOMER HAD APROBLEM WITH OUR CUSTOMER ,AND ME AS AMECHANICLAL ENGINEER FOUND THE PROBLEM

Two stroke and four stroke engines, T w o Stroke and Four Stroke Engines:...

T w o Stroke and Four Stroke Engines: In  the two stroke engines thermodynamic cycle is completed in One revolution of crank shaft whereas in 4 stroke engines the cycle is c

Form tool design, I want to make a form tool for lathe for making a convex ...

I want to make a form tool for lathe for making a convex groove of 3 mm radius. tool material will be tungsten carbide. I want to know the dimensions of tool. What is the procedure

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd