Evaluate mechanical work - thermodynamics, Mechanical Engineering

Evaluate mechanical work in different steady flow process:

Work done by steady flow process
2386_Evaluate mechanical work.png 
and work done in non flow process,
430_Evaluate mechanical work1.png 

1. Constant Volume Process; W1-2 = V(P1 - P2)

Steady flow equation

dq =  du =  dh +  d (ke) +  d (pv)

Now h = a + pr

By differentiating

dh =  du +  dtper

=  du =  pdv =  vdp.

1276_Evaluate mechanical work2.png

 

Posted Date: 10/15/2012 2:28:35 AM | Location : United States







Related Discussions:- Evaluate mechanical work - thermodynamics, Assignment Help, Ask Question on Evaluate mechanical work - thermodynamics, Get Answer, Expert's Help, Evaluate mechanical work - thermodynamics Discussions

Write discussion on Evaluate mechanical work - thermodynamics
Your posts are moderated
Related Questions
A ball is thrown from a point with a speed V  at an angle of projection  θ . From the same point and  at the same instant, a person starts running with a constant speed V/2 to catc

What do you mean by sensitivity in a governor?

when does the cyclic service apply for pressure vessels in batch plant (operation)

Line Designation Tables (LDT's) (Appendix "D") are initially generated by the Piping designers. Design conditions are inputed by the Process discipline, and the Mechanical Engineer

A jet of water moving at 8 m/sec. impinges on a concave-shaped vane to deflect the jet through 120 o when stationary. If the vane is moving at 5 m/sec., determine the angle of jet

Torsion of a Cylinder Let a cylinder of length  l  and radius  R  be clamped at one end and twisted at the other end by applying a torque τ about the axis of the cylinder. Each

Calculate strength coefficient: A copper specimen of 64 mm gauge length and 12.80 mm dia. was tested in tension. Following two diameters were recorded in the plastic range of

Beam: Sol.: A beam can be defined as a structural element which has one dimension (length) considerable larger As compared to the other two direction, which is breadth an

A copper-silver bimetallic wire, 1 cm in diameter, is prepared by co-extrusion with copper as the core and silver as the outer layer. The desired properties along the axis parallel

Q. How to observe water level? Site for installing gauges should be properly selected. The reach should be reasonably straight and of uniform cross· section and slope. The leng