Estimate elapsed time and height , Mechanical Engineering

Phase 1

Initially ALL Valves A, B, C, D, E and F are closed.

 ALL Tanks A, B, C, D, E are separated and each sealed from the atmosphere.

Tank E initially has 2' of air @ 32.476 psi.   15' x 27' x 2'

Tank C and Tank B initially contain air @ 32.476 psi

Pipe K initially is 12" id x 5' @ 32.476 psi

Tank A:  15' x 27' x 50'    20,250 ft3

Tank D:  100' x 100' x 100' clear water

Phase 2

Valve D and F are opened 1st.

Valve E, A and B are opened 2nd.

Valve C remains closed.

When Tank C and Pipe K have exhausted all  air, valves A, B and E close simultaneously. Valves F and D remain open.

  1. What is the elapsed time for air in Tank C and Pipe K to move to Tube B?
  2. What is the height and psi of Air in Tank E and Tank A?
  3. What is the final height and psi of air column Tube B Section F and G?
Posted Date: 4/6/2013 5:37:28 AM | Location : United States







Related Discussions:- Estimate elapsed time and height , Assignment Help, Ask Question on Estimate elapsed time and height , Get Answer, Expert's Help, Estimate elapsed time and height Discussions

Write discussion on Estimate elapsed time and height
Your posts are moderated
Related Questions
Evaluate power transmitted by shaft: How do you evaluate power transmitted by shaft (P)? Sol.: Consider force 'F' Newton's acting tangentially on shaft of radius ' R '.

Q. What is Expansion Joints? Expansion joints are used to accommodate thermal growth in piping and pressure vessel applications. The metal bellows, an integral part of an expan

The Radius Dimension Command The Radius command is quite identical to the Diameter command except that the dimension measurements a radius rather than a dimension and the resul

Improvements Required - Industrial Safety The outlining of association of safety engineering, as done above, with quality, productivity, profit etc. has also tended to make im

What are the problem arise in pile foundation Problems can also arise in providing pile foundations in residual soils which are underlain by sloping rock. Special rock sockets

Sweep Representations  The simplest form of sweep is that produced by sweeping a two-dimensional area along an axis perpendicular to its plane. This form of sweep is most usefu

Q. Inlet channel of the exchanger? The inlet channel of the exchanger shall be designed to minimize flow turbulence and erosion of the refractory liner and the tube inlet area.

Q. Corrosion resistance of the nickel-based alloys? The corrosion resistance of the nickel-based alloys can also be significantly affected by other variables such as velocity a

what is interference and undercutting?

A pump station has been designed to lift water out of a 6 metre deep pit (vented to atmosphere) via a centrifugal pump mounted at ground level. Liquid conditions