Discuss endp assembler directive, Electrical Engineering

Assignment Help:

Discuss the ENDP assembler directive with example

ENDP: It is stands for End Procedure, which informs assembler the end of a procedure. Within assembly language programming, subroutines are termed as procedures. A procedure may be an independent program module to provide specific result or the needed value to the calling program. It is used together with PROC directive for enclosing procedure. The common format of ENDP directive is as:

 Procedure Name ENDP


Related Discussions:- Discuss endp assembler directive

Determine the e.m.f., A 6-pole armature has 1000 conductors and a flux per ...

A 6-pole armature has 1000 conductors and a flux per pole of 40mWb. Determine the e.m.f. generated when running at 600 rev/min when (a) lap wound (b) wave wound.

Gets parameters data display, On running the simulation, a data display wil...

On running the simulation, a data display will automatically open, similar to that shown in figure. The red circle is the source mismatch stability curve. This will give an indicat

Factors affecting frequency response of an amplifier, Q. What is their rela...

Q. What is their relation with gain? What are the factors affecting frequency response of an amplifier? Some amplifiers should be "flat" across a band of frequencies. In other

The electrical circuit sign convention, The Electrical Circuit sign convent...

The Electrical Circuit sign convention Notice that current leaves a source at its high potential (positive) terminal but enters a load at its high potential (positive) ter

D flip flop - introduction to microprocessors, D Flip Flop As we have ...

D Flip Flop As we have seen  in the SR flip flop  when the inputs  S= R  are applied the forbidden or indeterminate state occurs.  This state can destabilize the SR file flop.

Define transmission-system efficiency, Q. Define Transmission-system effici...

Q. Define Transmission-system efficiency? The transmission-system ef?ciency is de?ned as the ratio of the real power delivered to the receiving-end bus to the real power transf

Effect of power factor correction capacitors, For a 50kW three phase rectif...

For a 50kW three phase rectifier connected at 415 V to a point of common coupling with a short circuit capacity 500kVA modelled as an inductive source, design filters to make the s

Explain the parallel in - parallel out shift registers, Explain the Paralle...

Explain the Parallel In - Parallel Out Shift Registers? For "parallel in - parallel out" shift registers all data bits show on the parallel outputs immediately following the si

For sign flag - conditional jumps , For  Sign  Flag JP ( jump  on ...

For  Sign  Flag JP ( jump  on plus ) Jump  on minus ) Instructions JP  transfer  the execution of the program to the specified  memory  address if  sign  flag is set (S=

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd