Direct addressing , Electrical Engineering

Direct Addressing

In this  addressing  mode one  of the  operands is the  data stored  in the memory. The memory  address of the  operand is directly  given in the instruction itself.

Example

STA 3050H

LDA 2345H

IN 01H

OUT 02H etc.

Posted Date: 4/5/2013 3:08:01 AM | Location : United States







Related Discussions:- Direct addressing , Assignment Help, Ask Question on Direct addressing , Get Answer, Expert's Help, Direct addressing Discussions

Write discussion on Direct addressing
Your posts are moderated
Related Questions
Diode Schematic Symbol The diode in figure is a unidirectional device. Electron current just only flows in one direction, against the arrow, corresponding to forward bias. The

Discuss merits and demerits of Macro over procedures.  The MACRO directive informs assembler the starting of a macro which is used with ENDM directive to enclose a macro. The

is armature reaction good or bad for dc generator?

In terms of negative feedback, there exists an analogy between the operational amplifier and the power-steering mechanism of an automobile. The hydraulic pump is analogous to the p

under three phase 4 wire load unbalanced distribution network how to calacualte the voltage across the load when no load resistance is specified, however the real and reactive powe

Interfaced 2k X 8 (i.e 2716) EPROM using multiple input NAND gate decoder for memory locations FF800H-FFFFFH. Simple NAND gate Decoder:  While the 2k x 8 EPROM is used so addre

With the development of cheap and reliable operational amplifiers the need to design amplifier circuits has disappeared. However it is still necessary to utilise these devices in a

Q.   Write a short note on types of enclosure of machine. Sol.       The various types of d.c. machine :              (1) Magnetic frame or Yoke              (2)

Q. Show the Classifications of Data Network? Classifications of Data Network: Data Networks are categorized according to their geographical coverage: • Wide area networks

Q. Determine v o /v i for the circuit shown in Figure if the op amps are ideal.