Difference between object oriented and object based language, Electrical Engineering

Object based languages don't support Inheritance where as object oriented supports. C# is a object oriented language due to it supports inheritance and asp.net is not a language it is a technology

If the language supports only 3 features i.e. (data encapsulation, data abstraction $ polymorphism).then it is said to be object based programming language. If the language supports all the 4 features i.e. (encapsulation, abstraction, polymorphism $ also inheritance )..then it is said to be object oriented programming language.

 

 

Posted Date: 4/6/2013 2:59:51 AM | Location : United States







Related Discussions:- Difference between object oriented and object based language, Assignment Help, Ask Question on Difference between object oriented and object based language, Get Answer, Expert's Help, Difference between object oriented and object based language Discussions

Write discussion on Difference between object oriented and object based language
Your posts are moderated
Related Questions
Q. In the magnetic circuit shown in Figure the center leg has the same cross-sectional area as each of the outer legs. The coil has 400 turns. The permeability of iron may be a

Why maximum power output is given by a machine at an efficiency of 50 percent?

Design a low noise amplifier using an Infineon RF transistor BFP640. The amplifier is to be used to amplify the L2 GPS signal and so the centre frequency is 1227MHz and bandwidth 4

Q. Explain about 'Emitter Follower'? EMITTER FOLLOWER : An emitter follower circuit shown in the figure is widely used in AC amplification circuits. The input and output of the

Q. The K map of a logic function is shown in Figure. (a) Obtain a POS expression and its corresponding realization. (b) For the purpose of comparison, obtain the correspondin

I need someone help me to do electronics formal lab report, I tried many time to submit it but I couldn''t? plz help me

Drift Current Density and Conductivity: Consider a conductor of length / meters and cross sectional area a square meters, as shown in Fig. Let the number of free electrons ava

a cast steel has minimun diameter of 200 mm and a cross sectional area of 250/1000000 m . calclate the mmf to produce a flux of300/1000000 Wb.


The normalized signal xn(t) has a bandwidth of 10 kHz and its power content is 0.5 W, while the carrier Ac cos 2πfct has a power content of 200W. Find the bandwidth and the power c