Determine the armature current and power factor of the motor, Electrical Engineering

A three-phase, wye-connected, 2300-V, 60-Hz, round-rotor synchronous motor has a syn- chronous reactance of 2 per phase and negligible armature resistance.

(a) If the motor takes a line current of 350 A operating at 0.8 power factor leading, calculate the excitation voltage and the power angle.

(b) If themotor is operating on loadwith a power angle of -20°, and the excitation is adjusted so that the excitation voltage is equal in magnitude to the terminal voltage, determine the armature current and the power factor of the motor.

Posted Date: 6/14/2013 7:48:31 AM | Location : United States







Related Discussions:- Determine the armature current and power factor of the motor, Assignment Help, Ask Question on Determine the armature current and power factor of the motor, Get Answer, Expert's Help, Determine the armature current and power factor of the motor Discussions

Write discussion on Determine the armature current and power factor of the motor
Your posts are moderated
Related Questions
Q. Write short note on a negative clamper ?   A circuit which places the negative peak of a signal at a desired level is known as a negative clamper (1). During the

Disadvantages of SDR 1. Power consumption is more due to rapid switching of modes 2. Hardware design is not easy 3. Software bugs exist in the system

area bounded by the curve y=3x(x-2)^2 and the x-axis

HOW ARE FLIP-FLOPS USED IN BINARY COUNTERS

DAA Decimal Adjust Accumulator Instruction This  instruction adjusts the contents  of the accumulator  into BDC (Binary Coded Decimal )  form  after a BCD  addition. It should

The torque produced by each conductor in the field will be:  where A is the area of the armature winding in the magnetic field, Ia is the current in armature winding, and B

Q. What do you mean by Sign Bit? The sign bit is like simple as it gets 0 denotes a positive number and 1 denote a negative number and flipping the value of this bit flips the

Microcomputer A microprocessor is a  general purpose central processing  until of a digital  computer system. It has  arithmetic  logical unit  control circuits and a set of r

hello, I do have some exams or test samples which are related to control and procces engineering. Can you have them solved with ilestrastion of all solving steps

Determine the magnetic flux: A coil is wound uniformly with 300 turns over a steel ring of relative permeability 900, with a mean circumference of 40mm and cross-sectional are