Electrical network details:

1          single line diagrams with conductor sizes, transformer locations, consumer location, lengths, capacitors, and load, etc.,

2          parameters of equipment, devices and conductors, and

3          load data such as peak load, diversity factor, power factor and etc.

Figure: Details of a Distribution Transformer

•          LT network

1          section length,

2          conductor size of each section,

3          connected load for each group of consumer,

4          number of consumers in each group, and

5          total connected load on the transformer.

Posted Date: 2/8/2013 6:37:37 AM | Location : United States

Ask an Expert

Related Discussions:- Details of a distribution transformer, Assignment Help, Ask Question on Details of a distribution transformer, Get Answer, Expert's Help, Details of a distribution transformer Discussions

Write discussion on Details of a distribution transformer
Your posts are moderated

Write your message here..

Related Questions

Use of cro for frequency measurement, Q. Explain the use of CRO for frequen... Q. Explain the use of CRO for frequency measurement.   Measurement of frequency: The frequency of the periodic signals is easily measured with a CRO. The frequency of a si

What is meant by biasing transistor, Q. What is meant by biasing transistor... Q. What is meant by biasing transistor? The purpose of dc biasing of transistor is to obtain a certain dc collector current at a certain dc collector voltage. These values of c

Determine l and c of the band pass filter circuit, Q. Determine L and C of ... Q. Determine L and C of the band pass filter circuit of Figure to have a center frequency of 1 MHz and a bandwidth of 10 kHz. Also find the Q of the filter.

Stupidity, 100 words 100 words

Define hrq, Define HRQ? The hold demand output requests the access of t... Define HRQ? The hold demand output requests the access of the system bus. In non- cascaded 8257 systems, this is linked with HOLD pin of CPU. In cascade mode, this pin of a sla

Determine the resultant line current and power factor, Q. A three-phase loa... Q. A three-phase load, connected to a 440-V bus, draws 120 kWat a power factor of 0.85 lagging. In parallel with this load is a three-phase capacitor bank that is rated 50 kVAR . D

Voice operated wheelchair, pls give me the schematic of it pls give me the schematic of it

Combination of logic gates, what is the definition of logic gates what is the definition of logic gates

Rise time - power semiconductor devices , Rise  Time (t r ) During  ri... Rise  Time (t r ) During  rise time voltage falls from 90% V a to 10%  where  V a where V a is the initial  anode  voltage. In terms  of current  time taken  by anode  curre

Determine the current needed in the coil to produce a flux, Q. Consider the... Q. Consider the magnetic circuit shown in Figure. Assume the relative permeability of the magnetic material to be 1000 and the cross-sectional area to be the same throughout. Deter