Design of beam, Civil Engineering

Design of beam
Posted Date: 3/16/2013 4:00:18 AM | Location : USA







Related Discussions:- Design of beam, Assignment Help, Ask Question on Design of beam, Get Answer, Expert's Help, Design of beam Discussions

Write discussion on Design of beam
Your posts are moderated
Related Questions
Discuss about the term - End Zone It is the length of a post-tensioned concrete member, at the end, which is required to get a distribution of prestress over the whole of the c

the two side are 17 cm and 28 cm long. and the lenght of the drawn to the third side is equal to 19.5cm. find tghe distance from an endpoint of this medianto the longest s8ide


A finish-to-finish activity is best described as: The "from" activity must finish before the "to" activity can finish The "from" activity must finish before the "to" acti

Q. What do you mean by Ozone Test? Some research and studies determined that the ozone test was unnecessary as this affects only the surface layer.  In un-stretched rubber, ozo

What is WBM road. How it is constructed?

The wet weight of a sample is missing in a Proctor test. The oven-dry weight of this sample is 189 N. The volume of the mould used is 1000 cm 3 . If the degree of saturation of

Explain the shrinkage strain of concrete Shrinkage of concrete depends only on the interval of time and the moisture conditions, but is independent of the stresses in the membe

Q. Write short note on SKV  process of thermit welding? This term is used for welding by Alumino thermic process with short preheat time. The time required for preheat with pet

A group of 16 piles of 50 cm diameter is arranged with a centre to centre spacing of 1.0 m. The piles are 9 m long and are embedded in soft clay with cohesion 30 kN/m 2 . Bearing r