Compute monitoring and control, Mechanical Engineering

Compute Monitoring and Control: These are the direct application in which the computer is connected directly to the manufacturing process for the purpose of monitoring or controlling the process.

Manufacturing Support Applications: These are the indirect application in which the computer is used in support of the production operations in the part but there is no direct interface between the computer and the manufacturing process.

Posted Date: 3/26/2013 7:35:44 AM | Location : United States

Related Discussions:- Compute monitoring and control, Assignment Help, Ask Question on Compute monitoring and control, Get Answer, Expert's Help, Compute monitoring and control Discussions

Write discussion on Compute monitoring and control
Your posts are moderated
Related Questions
Over-Hanging and Cantilever Beam: Over-Hanging Beam: The beams on which one end or both ends are overhang are called as overhanging beam. 3. Cantilever Beam:

Determine the dimensions of the tank: A conical water tank is to be fabricated from steel plate of 10 mm thickness. The shell should contain an apex angle (α) 15o. If the perm

Limitations of resistance welding 1). Pressure - tight joints are achieved only with flash butt welding. Resistance welding is not recommended for high pressure joints a

Q. Describe Organic binders and its working? Organic binders: The binders are most frequently used in core making. Cereal binders are obtained from wheat, corn or rye; resins

Q. Show the support locations for truckable skid? Unless instructed otherwise by Engineer, support locations for truckable skid shall be determined by skid Vendor. Support loca

what is interference and undercutting?

Heat generated uniformly in Stainless steel plate having k=20 W/m. 0 C. The thickness of the plate is 1cm and the heat generation rate is 500 MW/m 3 . If the two sides of the plate

1. Greater Design Freedom : Any changes that are required in design can be incorporated at any design stage without worrying about any delays since there would hardly be any i

An open topped tank with a base area of 1m2 contains a layer of water 0:5m deep below an oil layer 1m deep. If the densities of water and oil are 1000kg=m3 and 850kg=m3 respectivel

Q.  W rite down the basic formula for maximum bending moment in some ideal cases. Sol.:   Ber m together with nature of load Maximu